Plate Bearing Test Apparatus

This is for estimating the bearing capacity of shallow foundations in situ and for the design of flexible pavement. In the test procedure a steel plate is subjected to gradually increasing load and settlements of the plates recorded. The out fit consists of50 tonne hydraulic jack with separate pumping unit fixed to it a 0 - 500KN x 0.5KN. 1No. Pressure gauge and flexible metal pipe5 mtr. long 1No. Special ball and socket arrangement between the jack and the bearing plate 1 No. Extension rod 12mm dia x 25 cm long for taking dial gauge readings 16 Nos. Magnetic base with female thread on top for holding extension rod 4 Nos. Top end plate, 50mm, dia with male thread for fitting onto the extension rod sand positioning the dial gauge plunger 4 Nos. Column 15cm dia x 25cm long with flanges complete with four bolts and nuts 2 Nos.Column 15cm dia x 50cm long with flanges complete with four bolts and nuts 1 No. Bridge support of welded steel angle construction, 5 mtr. Span and stands approximately 30 cm. High. Fitted withtwo quick release clamps a for positioning and holding the dial bracket 2 Nos.Other Details: Plane M.S. plate 60cms x 60cm . Square x 60 cms. Square x 25mm thick. Plane M.S. plate 45cm x 45cm x squarex 25mm thick. Plane M.S. plate 30 cms x 30 cms x 25mmthick. Dial Gauge 0.01mm x 25mm - 4 Nos. Accessories: Plane M.S. 75mm x 25mm thick Plane M.S. 50cm x 25mm thick Grooved M.S. plate 60cms x 60cms x 25mm thick Grooved M.S. plate 45cms x 45cms x 25mm thick Grooved M.S. plate 30cms x 30cms x 25mm thick Grooved M.S. plate 75cms x 75cms x 25mm thick